On last modeler meeting my brother please me if I can built him some RC Boat.
He was excited by my Fisher boat Naxos.
So it was on me to find some plans for fisher boat.
I remember on plans of old Norwegian fisher boat model called ARTUR.
It's cult model in Czech and Slovak republic 😀 .
Standard length of this model is around 65 cm.
For better manipulation and transporting I mus make shorter version.
So I remake the plans and now I start built model with 41 cm length.
I hope you will enjoy the build with me.

Her is the first sheet of plans for this build.

Keel - 4 mm hard ply wood
Ribs - 3 mm Birch ply wood
Hull cover - 4x2 mm spruce planks covered with one layer of fibreglass 80g/cm2.
Cabins - 1.5mm hard ply wood

Today I buy 155 mm shaft, coupling and 3 blade propeller with 30 mm of diameter.

Next update about start of build.

So today I find some free time and start work on hull for ARTUR.
Work goes well so from morning to lunch I prepare complete frame for covering with planks.

Today I cover the hull with planks. I fix it with fast glue.
When the hull will be done I coat inner side with epoxy.

So the hull is ready for Impregnating with epoxy. Then will be covered with deck.

from last update I make some progress in build.
After coating inner side with epoxy, I cover the deck with planks. Then I sand the deck and cut the holes for superstructures and service access. Then I finish the sides planking and start with superstructures. On last photo you can see the wires for position light on front mast. I cut two grooves on sides of mast and then I stick in two wires with glue and putty. After sanding its almost invisible.
(guys sorry for my English 😁 , if you see some errors just let me know 😛 )

So the hull is covered with one layer of 80g fibreglass.
and I make some littleness on board.

Hello peoples, after long time I attached the update of progress on ARTUR.
Job on hull is almost done. Now I work on super structures and lights and some deck details. I hope Brother will like it 😁