Started building Deans Marine Libertyship Robert E. Perry finished
Lenth 54 1/2” beam 7 1/2” weight 35 lbs. Power is Deans motor Falcon 3671 6 volt 1500rpm 3.19mm shaft and prop 147-18 brass propeller 50-L-4bl-M4.
Kit is very nicely done all fittings and hardware are included with the kit. The hull is detailed and I have lined the inside of the hull with 2 x 2 oz. fiberglass cloth and resin to give it more rigidity. I have installed the motor and prop shaft along with the rudder which I replaced since the kit supplied rudder was cast resin and only had a 3/32 dia shaft, I’m sure it would work fine but felt better with something a little more substantial. Added 5 lbs of ballast I used shot and installed sub floor in hull. Equipment installation and deck fitting, added 1/8” plywood as deck and styrene on top.

Added 5 lbs of shot to the hull and installed sub floor.

Began adding bulwark stays cut with chop tool and secured with thick CA should take a while also searching net for oval shaped eyelets to simulate Hawser openings.