Submarine Sunday

Gestartet von Doogle vor 3 Jahren

4 Antworties 25 gefällts Letzte Aktivität: vor 3 Jahren

Submarine Sunday

Doogle, be wary of a servo that shows ANY intermittency after even momentary partial immersion. I wud swap it out. Why risk losing a $200 boat when a $20 servo dies ? Been there, done that, I was just fortunate that a young lady on a PWC rescued my dead-in-the-water hulk.

VA3ROD

Gefällt von quattroo and Scratchbuilder and

#4 vor 3 Jahren

Submarine Sunday

From observing another's experience the biggest problem is having the power on with the electronics all wet.
Roy

Gefällt von quattroo and Doogle

#3 vor 3 Jahren

Submarine Sunday

Chris.
Sounds as if you may have got away with major damage,but I would keep an eye on that servo.
There but for the grace of God etc 🤞
Regards
Bill

Never give up.It will come right in the end.

Gefällt von quattroo and MouldBuilder and

#2 vor 3 Jahren

Submarine Sunday

Fit bilge pump and some buoyancy to stop it happening again.
Only a suggestion, cheers Colin.

Fair winds and calm waters,
COLIN.

Gefällt von quattroo and MouldBuilder and

#1 vor 3 Jahren

Submarine Sunday

From my earlier post on Sunday regarding the impromptu submarine transformation of my patrol boat 🚢 at the lake -well after 4 days drying out in the "studio " I tentatively wired it all up again after cleaning all the electrical components with switch cleaner etc and hey presto, it all came back to life. The rudder servo was a bit buzzy to start with but then seemed to quieten down again. All appears on the surface (excuse the pun) to be good, a very fortunate escape this time, probably not the last. Probably start a rebuild blog soon on this one.

Gefällt von quattroo and RogerA1 and

Anmelden zu diesem Thread beizutragen.

MODEL BOATS WEBSITE

Submarine Sunday

Follower (4)

Submarine Sunday

Submarine Sunday

Submarine Sunday

Submarine Sunday

Submarine Sunday