brushed motor problems

Gestartet von Bob the boilerman vor 3 Monaten

12 Antworties 11 gefällts 0 Follower Letzte Aktivität: vor 3 Monaten

#13 vor 3 Monaten 36

It sounds like a current overload for the speed controller which may activate a cutout to prevent heating and fire. Look at the current ability of the controller (search it on online) then put an ammeter in series with the circuit to see what amps are being drawn by the motor. Obviously the current draw increases when the prop turns in water due to the water resistance on the prop.

Gefällt von AlessandroSPQR and Bob the boilerman

#12 vor 3 Monaten 36

They're located on the outside and about quarter of an inch wide small little plastic pins And there is usually six little pins sticking up you can plug it into for the type of battery that you're using and if you want a reverse forward control Do you have the instruction manual that came with the Unit It should show you the positioning of the for different types of battery and forward and backward movement on your transmitter

Gefällt von Bob the boilerman

#11 vor 3 Monaten 40

@JohnB9 looks like a sealed unit, but I can look at the old one, not noticed any jumpers

#10 vor 3 Monaten 41

Are there jumpers on the controller

Gefällt von Bob the boilerman

#9 vor 3 Monaten 44

@BernhardP the present motor isn’t operating, so I suspect the current draw will be zero. A smaller motor may work, and give me an idea of what current is available , especially if I add load.

#8 vor 3 Monaten 45

Einem kleineren Motor fehlt dann die Kraft.Nimm einen kleineren Propeller.

#7 vor 3 Monaten 46

@BernhardP thanks for the reply.

Not tried to measure the amps from the controller yet, it’s the correct regulator for the model, may try that with a smaller motor, if I can find one.

#6 vor 3 Monaten 47

Wie viel Ampere bringt denn der Regler?
Ist der Regler für Gleichstrom?

#5 vor 3 Monaten 49

@JohnB9 thanks, but motor runs well when connected directly to battery

#4 vor 3 Monaten 51

@Bob the boilerman make sure the controller is correctly wired, do not switch + and - wires on the speed controller. If the motor runs in the wrong direction rewire the motor, not the ESC

Gefällt von AlessandroSPQR and RNinMunich and

#3 vor 3 Monaten 55

Try connecting it to another motor and see if it works then stays on

Gefällt von AlessandroSPQR and Bob the boilerman

#2 vor 3 Monaten 55

bad brshers

#1 vor 3 Monaten 60

brushed motor problems

hi, sorry for the intrusion, aeromodeller here (sorry) but I hope someone can point me in the right direction.
I'm trying to fix my Grandson's HTX vortex model boat, initially I thought the R/C receiver and motor control card was burnt out. So bought a replacement.
Steering servo works ok, the motor works when connected directly to a 2S battery, and I'm measuring 7.5V at the output wires of the controller. But when I connect the motor to the controller (boat in water) then I may get a little snatch of a run, then nothing. Any suggestions, summer hols are going by and would love to get him on the water again.

Gefällt von RNinMunich and hermank

Anmelden zu diesem Thread beizutragen.

MODEL BOATS WEBSITE

brushed motor problems

brushed motor problems