Hafenverzeichnis
Highlander Clyde Puffer,(Mountfleet.)
Spezifikationen
- Bootslänge
- 30" (76.20 cm)
- Bootsgewicht
- 212g (7 oz)
- Motor-Typ
- Gas / Petrol
- Antriebstyp
- 256
- Propeller
- Single
- Propellertyp
- 314
- Propellergröße
- 331mm
- Laufzeit
- 355 min
- Modellgeschwindigkeit
- 370 km/h (229.9mph)
Fotos
Über dieses Boot
Highlander is a Mountfleet kit and as the boiler and steam engine are both at the rear end, this leads to some problems regarding the layout of the steam plant, and the fact that the steam engine is in front of the boiler as opposed to behind. With the engine situated amidships a chain drive is required with shafts and bearings to the short prop shaft. As explained and shown with photographs in the build blog. The boiler is 3" x 6" and the engine is Cheddar 1/2" bore twin piston valve.
Gefällt von
Wird geladen…
Kommentare
Anmelden zu kommentieren.
Excellent build.
I think working out the problems we run into when building is a challenge we actually enjoy figuring out how to overcome.
I am looking forward to the maiden voyage I am sure you will share with us.
Barry
What a beautiful model.
Congratulations 👍
Regards
Bill.
😎