#7890

champdriver Canada Basis

Obermatrose  · 85 Pkte Ottawa, Canada Mitglied seit Apr 2023 Zuletzt online vor 11 Monaten
18 Beiträge 1 Follower
0 Boote im Hafen
0 Bau-Blogs
49 Erhaltene Likes

Follower

1 Follower

Neueste Aktivität

Zuletzt gepostet vor 2 Jahren
Forum replyMFA stock going to the Component Shop.Maybe there just updating there system with more goodies to drain my pocketbook.724 viewsForum replyMFA stock going to the Component Shop.Any ideas as to why when you try to go to the component shops website that you get an error msg “502 bad gateway”775 viewsForum replyComponent shop/ Action electronicsToradog I agree with you about the instructions but at the same time there are 10 or 100’s of YouTube’s on radio’s, esc’s, flying builds, boat builds, batteries, chargers and the list goes on but I have never …820 viewsForumComponent shop/ Action electronicsHi This is a curiosity question for everyone. I reside in Canada, not sure if that has anything to do with it but I have never been able to find any YouTube videos or other instructions for the component shop.…5 replies1,593 viewsForum replyMotors for a billing’s Fairmount AlpineHi Lew that’s not a bad idea and I can use the extra weight of the bigger motors to offset the amount of ballast that will be needed, I’d say that’s a win win😊 Michael542 viewsForum replyBending 7/32” tubingThanks for insight fella’s those are both good idea’s, I also came across the idea to plug one end fill with water and put it in the freezer for 36 hours and then bend. I might give this a try as I need to kee…652 viewsForumBending 7/32” tubingHi All Looking for the best way to bend 7/32 tubing I have the spring coil bending kit but is not large enough to handle this size tubing. Any thoughts? Michael7 replies1,258 viewsForumMotors for a billing’s Fairmount AlpineHi All I’m building a Fairmount Alpine and have purchased two MFA 800 motors for it but am starting think this may be over kill for the size of model. I thought about gearing them to slow them down but the gea…3 replies1,006 viewsForum replyWhat are peoples thoughts on the Frsky Tandem XE and EthosHi Dave I completely get where you are coming from and yes I think Frsky is moving to a proprietary or perhaps half and half measure with their ethos operating system. I also think for “techy” guys like me NOT…528 viewsForum replyWhat are peoples thoughts on the Frsky Tandem XE and EthosHi simplesailor yes I have been subscribed to that channel for a while he’s very good there’s also another fellow “Mr D” who is also very good. I’ve only recently (last couple of years) gotten back into rc aft…553 views

Delete this post?

Es wird von der Seite entfernt.

Diesen Entwurf verwerfen?

Ihr Entwurf wird gelöscht und kann nicht wiederhergestellt werden.

Sie haben einen unvollendeten Entwurf

Was möchten Sie damit tun?